威格士插裝式比例節流閥，CV1 6885

上海乾拓貿易有限公司

企業QQ；2880626089

電話；021-39526589

手機；13564956558

郵箱；13564956558@163.com

聯系人；居琦

此聯接機構，在用

與加工結合安裝

凸緣，提供了對準

泵電機。振動是

小化作為結果。

如果有必要移除或

取代以任何理由泵，

對準，而不需要實現

指示軸，并分別對齊

泵電機。

This coupling mechanism, used in

conjunction with the machined mounting

flange, provides for precise alignment of

the pump to the motor. Vibration is

minimized as a result.

If it becomes necessary to remove or

replace a pump for any reason, precise

alignment is achieved without the need

to indicate shafts and separately align

the pump to the motor.

The entire area around the splined

coupling is bathed in oil and sealed by a

static o-ring seal formed by the

mounting flange and the pump itself. In

addition, any minute shaft seal leakage

from the pump stays within the sealed

motor.

周圍的花鍵的整個區域

耦合在油浴并通過一個密封

由靜電形成O型密封圈

安裝凸緣與泵本身。在

此外，任何分鐘軸封泄漏

從內部密封泵住宿

發動機。

進口條件

標準模型需要一個積極的入口

壓力，通常通過使用一個提供

塔頂貯存器（圖1）或一個“L”

形儲存器（圖2），其油

平達電機泵空氣排放口

連接。較大正入口

壓力為2巴（29磅）。

維克斯建議積極入口

壓力對于所有電機泵

安裝。

注：在啟動，電

馬達應該充滿液壓流體Inlet Condition

Standard models require a positive inlet

pressure, normally provided by using an

overhead reservoir (Figure 1) or an “L”

shaped reservoir (Figure 2) with its oil

level up to the motor pump air bleed port

connection. The maximum positive inlet

pressure is 2 bar (29 psi).

Vickers recommends a positive inlet

pressure for all Integrated Motor Pump

installations.

NOTE: Prior to start-up, the electric

motor should be filled with hydraulic fluid

威格士插裝式比例節流閥，CV1 6885